Code Reader 3500 Uživatelský manuál stáhnout pdf (Strana 2)

Quickstart Guide

Hand Held CR3500 - To install a cable directly to the CR3500, correctly line up the 8-pin

DIN connector into the back end of the unit. The arrows on the connector should be facing

down (Figure 1). When the unit and the cable connector are lined up, ﬁ rmly push the cable

into the reader. The cable has a locking mechanism that will ﬁ rmly hold the cable in place

(Figure 2). To unattach the cable from the reader, you must pinch the plastic on the 8-pin

DIN and pull back to disengage the connector.

Figure 1 Figure 2

CR3500 with Cabled Handle - If a handle was purchased for use with the CR3500, the

8-pin DIN connector is at the bottom of the handle (Figure 3). Insert the 8-pin connector

and ﬁ rmly push the cable into the handle. The cable has a locking mechanism that will

ﬁ rmly hold the cable in place. If using the H2 cabled handle, for additional stability, there is

an optional cable attachment clip that can secure the cable to the handle with two threaded

screws (Figure 4). Screws shall be tightened to a torque setting of 2 inch-lbs.

Figure 3 Figure 4

The Code Reader 3500 (CR3500)

is a Multi-Interface Unit (MIU)

and is available with USB (6 ft. or

12 ft.), RS-232 and PS/2 cables.

All of the cables are connected

to the CR3500 with a 8-pin DIN

connector.

Code Reader 3500 - Cabled

C004418_01_CR3500_Cabled_Quickstart

Reader & Handle Assembly

H2 Cabled Handle or BH1/BH2 Battery Handle

The CR3500 utilizes the battery compartment to ‘snap

to’ the handle. For the H2 (only) push the 8-pin DIN

connector at the end of the reader into the ﬂ exible

connector at the end of the handle (Figure 10). For

all three handles, snap the reader onto the handle

matching the battery compartment to the battery

connectors, visible inside the handle (Figure 11).

Figure 10

Figure 12

Note: Readers with a MFG # of 012_05 or later can

be secured to H2 & BH1/BH2 handles with threaded

screws (Figure 12). To determine the Manufacturing #

of the reader, look at the reader’s battery compartment

and view the MFG # displayed (Figure 13).

H1 Handle

Slide the CR3500 into the handle, aligning the 8-pin

DIN connector to the stationary connector pin on the

handle (Figure 14). Push reader and handle together

ﬁ rmly until you feel the reader ‘click’ in place.

Reading Tips

Figure 13

Figure 11

Figure 14

C004418_01_CR3500_Cabled_Quickstart

1 2

Komentáře k této Příručce

Žádné komentáře

Code Reader 3500 Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Čtečky čárových kódů Code Reader 3500